Plastic Closure Mould

Plastic bottle cap mold: This is a set of plastic-covered bottle cap injection mold. At first, the customer wanted to make a two-color mold. Later, because of concerns that the product will not go out of volume, he decided to make an over-mold mold. I believe the product picture you see, isn’t it? I think it’s pretty, but it’s actually pretty. The final customer produced 200,000 products. Row position design specification 2. Pressure lock form

2.1 When the depth of the row position in the front mold exceeds 2/3H of its height, it is best to use the original mold body as a pressure lock.

The bottom corner of the press lock should be rounded to R.125”, and the hard piece is chamfered. 125”x45°.

2.2 When the depth of the row position is mainly in the rear mold, the pressure lock is made into a shovel chicken form. When the area of the glue position on the row position is large, a reverse lock is required.

2.3 If the area of the glue position on the row position is small, the shovel chicken can be made into the form of Figure 22.8, and the height of the pressure lock surface h must be greater than or equal to

The row position is 2/3H high.

For plastic bottle cap molds, please contact Shenzhen Qunxingwang Mould Technology Co., Ltd. Gary Gao: qxwmould_co_ltd@163.com

Mould Name: Custom Plastic Mould
Part Material: TPE
Product Size: ¢34.96X32.97 mm
Product Description:  Plastic Closure Mould
Mould Cavity: 2 cavities
Mould Size: 180*250*333 MM
Mould Cavity Steel: 1.2344(HRC48-52) 

Mould Injection System:  2 point hot runner
Mould Ejection System: ejector pin
Mould Cycle Time: 42s
Mould Life Cycle: 200,000
Lead Time: 30 working days
Mold export to: Europe

Hot Tags: plastic closure mould, China, suppliers, manufacturers, factory, customized, made in China, Two Shot Tool Construction Part, Two Shot Plastic Support Mould, Double Shot Plastic Injection Mold Products, 2K Injection Mold, Injection Moulding Parts, Double Shot Plastic Injection Mold Component