Two Color Plastic Part

Two-color plastic parts: This is a set of overmolding injection molds for small mechanical parts, and a simple overmolding mold. Design specifications of the row position 2. If the width of the row position "Z" exceeds 6-1/2", the guide bar must be positioned at the bottom of the row position.

When the width of the row Z" exceeds 4-1/2", two hypotenuses should be considered.

1.9 If the row position is too high, lower the starting point of the hypotenuse hole so that the row position slides smoothly.

1.10 If the bevel hole is enlarged, it will produce the function of delaying opening or closing of the row position.

1.11 If the front end of the row is a slender insert or a needle, and the weight of the insert only accounts for less than 25% of the entire row,

The length of the row can be calculated as C length.

If you need two-color plastic injection products, please contact Gary Gao of Shenzhen Qunxingwang Mould Technology Co., Ltd.: qxwmould_co_ltd@163.com

5. Row fixation method

(i) Slingshot, (ii) Slingshot wave, (iii) DME position clamp, (iv) SUPERIOR position lock, oil pump.

5.1 Built-in slingshot

5.1.1 The slingshot should be used as the positioning in the following situations.

1. The row is up (including diagonally up). (See Figure 22.11)

2. There are protruding thin inserts and needles in the row position. (See Figure 22.12)

3. There is a thimble at the bottom of the row. (See Figure 22.13)

Hot Tags: two color plastic part, China, suppliers, manufacturers, factory, customized, made in China, Motorcycle Mould, 2K Plastic Mold Making Part, Two Shot Tool Construction Part, Injection Moulding Parts, Coffee Machine Products Mold, Two Shot Plastic Support Mould